Split Speaker

Split Speaker

Audacity help: How to I combined the left and right speaker to be the same?

I am using audacity to make a ringtone and the mp3 is split into two different ones to represent the left and right speaker. This would be fine normally except a speaker is blown on my cell phone so it doesnt sound right when it plays. I need to know how to combined both into one

I don't have the program installed on this computer, but there should be an option to set it to mono, which will combine the two channels.

RE audio SX 18'' x2 2600 RMS split between 2 8 gauge speaker wire & 5v JVC head unit,amplifier putting out 36AC volts per channel

How To Extend Speaker Wiring? Home Theater Installation Tips

Step 1: Initially unplug your music system

Step2:  Now disconnect your speaker wire from the music/home theater system. As you go through the wire you can observe that the wire originating from each speaker consists of two metal wires covered by flexible latex which works as insulator.

One wire is the ground, while the other is the positive

The tips of the wire towards the Y junction must be peeled up to half inch.

Step 3: Buy some roll of wire the matches the one which is same as your speaker wire. This information is given in the literature of your system or some times written on the wire itself. Along with these buy some wire connectors or nuts and electricians vinyl tape.

Step 4: According to the distance you want the speakers to be from them system, cut the purchased wire. Then make a Y junction by splitting the ends of the wire. Remove the insulation over the metal wire up to half – inch.

Step 5: The only thing you have to do is to connect the old set and the new set of wires. It can be done in many ways. Among all soldering these two wires is the best option but a bit unsafe if you are soldering it for the first time. Using wire nuts is the best option in such cases. i.e. www.audiovideoking.com

Step 6: You can follow the same steps for multiple speakers.

Step 7: Finally you have to connect the extended wires to the amplifier. Generally the positive goes into the red one and the ground wire goes into the black one

Reconnect your system and enjoy music or movie of your choice

Home Theater Installation Home Theater Installers

About the Author

I have been in the Home Theater business for more than 7 years and I am the owner of www.audiovideoking.com. I was a field technician for 4 years and also a Directv field trainer.

No tags for this post.

Related posts

• No related posts.